KungFooBob wrote: Wed Sep 27, 2023 8:14 am
Seat covers actually look pretty good, but who do you get people in the back now, it looks like you've covered the seat pull?
They can get in the other side, the lever is in a different place & not covered... altho I've never had anyone in the back seat.
Pulled the drivers seat out today to fit the seat cover correctly. Found $0.85. Phaaaarque me, the seat must weigh 100lb. Seat back in, battery connected without any airbag detonations. Managed to get the PAX seat covered sorted in-situ
Polished the Rustoleum off my glasses from last weeks cabinet refinish.
Tool round up later (maybe)
Gave the fuel system the benefit of some Rislone snake oil last time I gassed it up. Actually had a noticeable improvement: easier start, smoother running, better mpg etc & there's no stink of fuel when it fires up. It was the 2 in 1 version of their snake oil. CEL has remained off since I dumped the stuff in the tank & cleared the codes with the scanner doodad.
Last time I gassed it up was around 18th Sept, fuel light came on this morning.. so damn near three months since I filled it & added the snake oil. Guess the next fill up will last me until sometime in February at this rate.
New shocks/struts/springy thingies should be here in a few days.
Swapped the cut front left with the rear to at least give me a fighting chance if it all goes pear shaped before I get to the tire store in a day or two. or four or five.
Brakes have been grinding for a while, I knew the front rotors were already fucked so ignored it for a month or so. Jacked it up yesterday, popped the front left wheel off & mic'd the rotor just for S&G's. Then cleaned up the wheel arch & the wheel, so now I have one spotlessly clean wheel inside & out. New rotors, pads & associated gubbins ordered yesterday. Should be here by the end of the week